radar / ew testing webinars -九游官网下载

pulse stability measurement of radar signals

in this webinar, we take a look at real-life examples of how to do performance measurements with complex burst and pulse sequences with the market leading r&s®fswp phase noise analyzers.

smallsat system architectures: design for testability

this webinar proposes a system architecture planning checklist to facilitate critical testing throughout the development cycle of small satellite payloads, gateway terminals, and user terminals.

more information

phase-coherent multichannel pulse analysis

this webinar explains the importance of phase-coherent measurements in a variety of real-world use cases and presents the relevant test and measurement solutions.

more information

testing next generation jammer systems

in this webinar you will learn how to check the correct parameters of the used jamming and deception techniques.

more information

testing trm performance in aesa radar antennas

in this webinar you will learn more about solutions for high test speeds and throughput as well as how to cover multiple tests with one set-up.

more information

doherty amplifier - measurement-aided development

this webinar introduces the doherty amplifier as a special case of the “balanced” amplifier genre. we will discuss design & test challenges and show implementation variants that make it possible to increase output power and improve efficiency.

more information

simulating radar signals for meaningful radar warning receiver tests

testing state-of-the art radar warning equipment with adequate rf and microwave signals is a challenging task for radar engineers. generating test signals in a lab that are similar to a real-life rf environment is considered a supreme discipline when evaluating advanced radars. today, there are intuitive and easy-to-use software tools available that take a lot of work off the hands of radar engineers.

more information

deceptive jammer / drfm testing

the webinar introduces the concept of digital rf memory jammers, describes their technology and the respective test and measurement challenges and solutions from rohde & schwarz.

more information

an introduction to direction finding

go back to basics in this webinar, which reviews the different direction finding technologies. direction finding technologies are often based on changes in amplitude, frequency, or phase. each of these technologies have their advantages and limitations.

radar signal generation

this webinar discusses the test requirements of next generation single-channel and multichannel digital receivers and demonstrates an efficient and comprehensive test solution based on the r&s®pulse sequencer software in combination with the r&s®smw200a vector signal generator.

more information

advanced multi-emitter radar simulation with off-the-shelf t&m equipment

test scenarios can range from simple pulses for component tests to full scale testing of complex radar systems. examples show how to map real signal environments with multiple emitters and interferers into vector signal generators to stimulate a system under test.

more information

improving the efficiency of your envelope tracking test setup

an increasing number of power amplifiers support envelope tracking technology to improve efficiency and therefore extend battery life in smartphones and tactical radios. this webinar explains the basic principles of envelope tracking and the test challenges involved in this technology.

more information